DTS XR 8 Wash User Manual download pdf (Page 7)

4- VOLTAGE AND FREQUENCY

The XR8 with electromagnetic ballast can operate at

5- INSTALLATION

XR8 may be either floor or ceiling mounted.

For floor mounting installations, the XR8 is supplied with four rubber mounting feet on the base.

For ceiling mounted installations, we reccomend the use of appropriate clamps to fix the unit to the

mounting surface.

The supporting structure from which the unit is hung should be capable of bearing the weight of the

unit, as should any clamps used to hung it. The structure should also be sufficiently rigid so as not to

move or shake whilst the XR8 is moving.

Four quarter turn fast locks placed on the base of the units,allows by using the two fast lock C clamps

provided in the box, to fix the unit in any position.

5.1- Safety cable

We recommend the use of a safety cable or chain connected to the XR8 and to the suspension truss in

order to avoid the fixture accidentally falling should the main fixing point fail. Make sure that the iron

cable or chain can bear the weight of the entire unit.

You may attach the safety chain to the two holes (A) located on the base of the fixture, as shown in the

picture below.

5.2- Protection against liquids

The projector contains electric and electronic components which should under no circumstances come

into contact with oil, water or any other liquid. The proper unit functioning would be compromised

should this occur.

230 V 50-60 Hz (Standard)

On request: 100 V 50-60 Hz /120 V 60 HZ

XR8 WASH

1 2 3 4 5 6 7 8 9 10 11 12 ... 27 28

No comments

DTS XR 8 Wash User Manual Page 7